Technical Info
Description
Hardrace Rear Camber Kit for Lexus GS 2nd JZS160 1998-2005 and Lexus IS 1st XE10 1999-2005 and more
Hardrace's rear camber kit for the Lexus GS 2nd JZS160 1998-2005 and Lexus IS 1st XE10 1999-2005 and more. It's the fix for uneven tyre wear on lowered cars, and lets you tune grip for road or track.
Built by Hardrace, the Taiwanese suspension specialist, as a quality upgrade over the factory part, with spherical bearing construction.
Key Features
- Adjustable camber
- Corrects camber after lowering
- Helps even out tyre wear
- Tune grip for road or track
- Bolt-on replacement for the standard parts
- Complete 2-piece set
What's in the Kit?
- Camber kit (2 pieces in total)
Fitment
- Lexus GS 2nd JZS160 1998-2005
- Lexus IS 1st XE10 1999-2005
- Lexus SC 2nd Z40 2001-2010
- Toyota Aristo JZS16 1997-2004
- Toyota Crown majesta JZS, UZS 17# 99-04
- Toyota Crown S17# 1999-2007
- Toyota Altezza XE10 98-05
Not suitable for: models other than those listed.
Installation
Replace the standard arms with the Hardrace kit, set them to the original length to start, then have camber set. Tighten all fixings to the vehicle manufacturer's torque figures with the suspension loaded at normal ride height. Have a full four-wheel alignment done after fitting. We recommend professional fitting.
Upgrade Further
- Hardrace Rear ARS Cancel Kit 3Pc Set Lexus GS 98-05
- Hardrace Adjustable Front Tension Rod With Spherical Bearings 2Pc Set Lexus GS300 98-05 SC
- Hardrace Front Upper Arm V2 Pillow Ball 2Pcs Lexus Gs 98-05 Sc 01-10 Extreme Lower Stance
Do I need an alignment?
Yes, camber and toe must be set by a full alignment after fitting.
Do I need this if my car is lowered?
If your tyres are wearing on the inner edge after lowering, a camber kit lets you correct it.
How much camber should I run?
For road use a small amount of negative camber is usual. Your alignment centre can advise for your setup.
Will it fit my car?
It is listed for the models in the Fitment section. If your car has a different engine, drive layout or market spec, check with us before ordering.
Is it road legal?
Yes, it is a bolt-on part for road and track use. Tell your insurer about any modifications.
Is it covered by a warranty?
Yes, Hardrace parts are covered against defects in materials and workmanship.
Is it a genuine Hardrace part?
Yes, we are a UK Hardrace stockist and supply genuine Hardrace parts.
The warranty on Hardrace products depends on the type of product, with a minimum warranty period of 2 years. This warranty does not cover damage caused by a car crash, improper use, negligence or normal wear and tear.
| Rubber bushes | 5 years |
| Spherical bushes | 2 years |
| Adjustable arms with rubber inserts | 5 years |
| Adjustable arms with spherical inserts | 2 years |
| Engine mounts | 5 years |
| Sway bars | Lifetime warranty |
| Bushes and endlinks | 5 years |
| Billet inserts | Lifetime warranty |
| Chassis brace | Lifetime warranty |
| Ball joints/tie rods | 2 years |
Why Buy From Us?
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
